This system offers additional protection while drilling by rapid shutdown upon uncontrolled rotation in the axis of the drill bit, e. I hope this helped you.Īctive Torque Control (only TE 76-ATC / TE 76P-ATC) The TE76-ATC / TE 76P-ATC is equipped with the Active Torque Control system in addition to the mechanical torque limiting clutch. If it is older than 2 years there will be a charge for the repairs.
Hilti te 76 atc parts breakdown free#
They will pick it up, repair it, and send it back to you in 3 working days FREE OF CHARGE. If your Hilti is less Than 2 years old, call Hilti. This is not available to the general public. To do this you with need a Hilti optical interface, a PC, and Hilti ODA Software. Once serviced or repaired, it will require resetting. This is to ensure that it gets regular service. It will continue to work for another 50 hours with the light on, then it will shut down completely. The service light will come on for the same reasons as mentioned above, but it will also come on after 200 hours of use. If you have the newer type TE905 with the large “D” Type handle at the back. To reset the light, simply cure the problem. Or more common the carbon brushes need replacing. Either there is a tight bearing which will increase the amount of current used to work the machine.
If you have the old type TE905, which is the one with the square type handle at the back, the service light will come on for 2 reasons. More then likely your connecting rod is broken. You will then have a snap ring to remove.Īfter that you can remove the whole cylinder assy. You will then have 8 5MM screws to remove. Once that is off your will have a spring and two roller bearings to remove before you can slide the bell off. It is regular threads but there will be loctite on it. You will then have to put a pipe wrench on the chuck to unscrew it. To remove the chuck you will have to put a chisel in the chuck.